Pine wood house bed

krāsā). Vēl vienai lamelei ir sākusi veidoties plaisa, bet tā kalpos vēl ilgi, jo ir kāju galā un zem tās ir vēl vairāki slāņi. Var nomainīt, var salīmēt, var arī pagriezt otrādi un atstāt kā ir. Izjaucot gultu jumtiņa detaļai vienā vietā atlūza mazs koka gabaliņš. Ir nelielas radošuma izpausmes kas acīs nekrīt, bet katram gadījumam nobildēju. Ja izdomāsiet gultiņu ietonēt, tad viss pārklāsies un gulta būs kā jauna, bet arī tāpat tā izskatās ļoti forši. Ir stabila un smaga, jo tas nav saplāksnis.

Bildē nav uzlikta, bet ir arī 4. maliņa. Mēs to neizmantojām un arī pasūtījuma laikā izrunājām ka mums to nevajag, bet ražotājs to tik un tā ir ielicis. Lai to uzlikt būs pašiem jāizveido 2 caurumi (ar bultiņām atzīmēts kur jābūt caurumiem - vienā pusē ir, otrā nav). Gultai var pārlikt gan guļamvietu gan maliņas par 1 līmeni augstāk - gadījumā ja tiek izmantots biezs/augsts matracis vai vienkārši ir vēlme pacelt guļamvietu augstāk.

">

I am selling a Latvian-made canopy bed (Tridubka), without a mattress, designed for a 160x80cm mattress. The external dimensions of the bed are 87x173cm, height to the canopy 128cm (+35cm canopy). I will also include an IKEA canopy as shown in the photo, in good condition - intended for an IKEA KURA bed, but can also be used for other beds. Located in Riga, Posma Street. In good condition, shows signs of use, therefore the price is very reasonable. Disassembled, ready to go to a new home. Signs of use are as follows: 2 slats (white) have been replaced. Another slat has started to crack, but it will still serve for a long time, as it is at the end of the leg and there are several more layers underneath it. It can be replaced, glued, or turned upside down and left as is. When dismantling the bed, a small piece of wood broke off in one place. There are some minor creative touches that are not immediately noticeable, but I have photographed them just in case. If you decide to paint the bed, everything will be covered and the bed will be like new, but it looks very cool as it is. It is stable and heavy because it is not made of plywood. It is not shown in the picture, but there is also a fourth edge. We didn't use it and also said when ordering that we didn't need it, but the manufacturer included it anyway. To install it, you will have to make 2 holes yourself (the arrows mark where the holes should be - there are holes on one side, but not on the other). The bed can be raised by one level, both the sleeping area and the rails, in case a thick/high mattress is used or you simply want to raise the sleeping area higher.